Calibrating a 5″ Raspberry Pi touchscreen in Jessie

Previously, I posted about a 5″ touchscreen for the Raspberry Pi.

But I did not mention calibrating the touchscreen.

After a week’s holiday, I came back and sorted this fairly easily.

I was using Raspbian Jessie from NOOBS 1.8

First I installed a new utility:

sudo apt-get install xinput-calibrator

 Calibration

To calibrate the touchscreen, go to the menu>preferences>select “Calibrate touchscreen”

Touch each of the red crosses on the screen in turn, then cut and paste the resulting snippet to the following file by using this command:

sudo nano /usr/share/X11/xorg.conf.d/98-calibration.conf

(this will create a new file and open it for editing)

My entries are below:

Section “InputClass”

Identifier “calibration”

MatchProduct “ADS7846 Touchscreen”

Option “Calibration” “120 3970 205 3920” #(enter your numbers here)

Option “SwapAxes” “0”

EndSection

Ctrl-O to save, Crtl-x to exit, and then reboot, and your pointer should follow your finger correctly!